Flexible, rubber end caps for capping Cast Iron, Plastic, or Steel pipe ends. Non-pressure, gravity flow applications only. Recommended for above ground installations. Easy to install and reuse.
Multiple sizes from 1.5" to 12".
COMPONENTS
Clamp: 301 Series Stainless Steel, Worm Drive (1) Cap: Molded, One-Piece, Elastomeric Sealing Cap
LEGEND: Cast Iron (CI) Schedule 40 Plastic (PL) Steel (ST)
RECOMMENDED TOOLS: Seekonk Torque Wrench - Pre-Set 60 in/lbs. with .3125” hex head screw
MISSIONMADE™ products are easy to install and reuse.
LEAKPROOF
Increased band tension secures pipe end, forming a watertight seal. Axially tapered design distributes and dissipates internal stresses. Strong, molded "ASTERISK" braces end cap against head pressure during testing.
RESILIENT
Synthetic rubbers permit considerable distortion withstanding tension and compression. More pliable, easier to install in cold weather applications than elastomeric PVC caps.
DURABLE
Synthetic rubber cap resists ultraviolet rays, ozone, fungus growth, natural soil erosive properties, and normal sewer gases
SECURE
Tight-fitting internal cone wedges inside pipe, balancing outward strains against steel clamp. Sealing “O” Rings under clamp prevent pipe end slippage for a reinforced joint seal.
ANTICORROSIVE
Stainless steel components resist corrosion in a variety of environments.
ADAPTABLE
For permanent or temporary clean outs. Independent clamp tightening adapts to different outside pipe diameters.